Remove the factory pedal

Remove the original throttle pedal assembly. Disconnect the cable, and remove the rubber pedal stop, leaving the hole open.

Open the right pedal mount

Gently bend open the right-hand pedal mount tab. You’re making room so the DBW bracket can sit correctly where the old rubber stop used to be. Do not over-bend — you only need enough clearance for the mounting plate.

Fit the DBW pedal (top bolt first)

Install the DBW pedal using the top bolt in the OEM rubber-stop hole. Leave it slightly loose so you can position the lower bracket correctly.

Mark, drill, and final install

Tilt the DBW bracket into final position. Mark lower holes, drill, and add nutserts. Bolt the pedal in firmly after nutserts are seated. Confirm pedal returns freely with no binding.